Durethan BKV130 000000

  _Mehr Infos 
  _Datenblatt ASTM (PDF) 



PA 6-Copolymer, 30 % glass fibers, injection molding, improved impact strength
ISO Shortname:  ISO 16396-PA 6/66-I,GF30,GR,S14-090
PropertyTest ConditionUnitStandardguide value
 dry as moldedconditioned

Mechanical properties (23 °C/50 % r. h.)
Tensile modulus1 mm/minlb/in²ASTM D 6381300000725000
Tensile elongation at break-%ASTM D 6384.07.0
Tensile stress at break-lb/in²ASTM D 6382320014500
Izod notched impact strength73 °F, 0.125 inft·lb/inASTM D 2563.44.1
Izod notched impact strength-40 °F; 0.125 inft·lb/inASTM D 2562.22.2
Flexural strengthlb/in²ASTM D 7903770021800
Flexural modulus-lb/in²ASTM D 7901160000682000

Thermal properties
Deflection temperature under load, Unannealed66 psi; 0.157 in°FASTM D 648419
Deflection temperature under load, Unannealed264 psi; 0.157 in°FASTM D 648392

Other properties (23 °C)
Densitylb/in³ASTM D 7920.049
Specific gravity-ASTM D 7921.36
Disclaimer for commercial products
This information and our technical advice - whether verbal, in writing or by way of trials - are given in good faith but without warranty, and this also applies where proprietary rights of third parties are involved. Our advice does not release you from the obligation to verify the information currently provided - especially that contained in our safety data and technical information sheets - and to test our products as to their suitability for the intended processes and uses. The application, use and processing of our products and the products manufactured by you on the basis of our technical advice are beyond our control and, therefore, entirely your own responsibility. Our products are sold in accordance with the current version of our General Conditions of Sale and Delivery.
Test values
Unless specified to the contrary, the values given have been established on standardized test specimens at room temperature. The figures should be regarded as guide values only and not as binding minimum values. Kindly note that, under certain conditions, the properties can be affected to a considerable extent by the design of the mould/die, the processing conditions and the coloring.
Processing note
Under the recommended processing conditions small quantities of decomposition product may be given off during processing. To preclude any risk to the health and well-being of the machine operatives, tolerance limits for the work environment must be ensured by the provision of efficient exhaust ventilation and fresh air at the workplace in accordance with the Safety Data Sheet. In order to prevent the partial decomposition of the polymer and the generation of volatile decomposition products, the prescribed processing temperatures should not be substantially exceeded. Since excessively high temperatures are generally the result of operator error or defects in the heating system, special care and controls are essential in these areas.
Conditioning in accordance with ISO 1110 (70 °C; 62 % r.h.)
Datum: 01.05.2019