Polyamide for coolant pipes GIT / WIT - Defects and how to avoid them
Icon HomeprocessmaterialsprocessingdefectsapplicationsE-Mailwechseln zu DE


Shrink holes Chambers
Fehler Lunker Fehler Kammerbildung
Cause: Shrinkage between the two outer frozen layers

Corrective: High water volume output, high holding pressure, slowly crystallizing material		 Cause: Water divides the melt because of too high injection pressure
Corrective: Decrease of injection pressure, increase of pressure holding period
   
Bubbles Foaming
Fehler Bläschen Fehler Schaumbildung
Cause: Water mixes with the melt and vaporizes afterwards

Corrective: Increase of pressure holding period		 Cause: gas mixes up with melt

Corrective: Increase of pressure holding period
© LANXESS, 2014. All rights reserved. Your use of this site is subject to our terms of use.